P2484W - 7 Hole, 90° Gusseted Fitting with Welded Corner

P2484W-No-Dimensions.png
Part No. Finish Product Weight / Piece (lbs)
P2484W EG 1.34
P2484W HG 1.41
P2484W GR 1.34

    Design Loads
    Design Loads - P2484 & P2484W (Bending Moment)
    Part Number Load Case  Minimum Ultimate Load
    (lbs)    		 Moment (in-lbs) Average Deflection at Design Moment
    Min. Ultimate Span/360
    (lbs)
    P2484

    		 A  1,030  10,300 3,400 0.126"
    B 3,400 34,000 11,300 0.149"
    P2484W

    		 A 1,150 11,500 3,800 0.112"
    B 4,800 48,000 16,000 0.180"
    Notes:
    1. Design Loads only apply to UNISTRUT brand products. Look for "UNISTRUT" on the part.
    2. Safety Factor = 3.0 based on static testing to the ultimate strength of connection.
    3. Two (2) 1/2" Unistrut Channel Nuts and Cap Screws torqued to 50 ft-lbs required for installation.
    4. Bolts can be located in any 2 of the 3 leg holes.

    General Specifications

    Standard Dimensions (Unless Shown Otherwise on Drawing):

    • Hole Diameter:  9/16"  (14mm)
    • Hole Spacing (From End):  13/16"  (21mm)
    • Hole Spacing (On-Center):  1 7/8"  (48mm)
    • Width:  1 5/8"  (41mm)
    • Thickness:
    • 1/4"  (6.4mm) with steel meeting or exceeding ASTM A1011 SS GR 33, or
    • 0.220" (5.6mm) with steel meeting or exceeding ASTM A1011 HSLAS GR 45

    Note:

    • When used for mechanical supports, load capacities of brackets and fittings should be in compliance with the American Standard Code for Pressure Piping.

    Materials & Finishes

    Materials & Finishes - Standard:

    • Base Metal: Steel conforms to ASTM A1011 SS GR 33, A1011 HSLAS GR 45, A36, A575, A576, or A635.
    • Electrogalvanized (EG):  Conforms to ASTM B633, Type III SC1
    • Unistrut Defender (DF):  Conforms to ASTM A1059
    • Hot Dip Galvanized (HG):  Conforms to ASTM A123 or A153
    • Perma-Green (GR):  Conforms to commercial standards for powder coating
    • Perma-Gold (ZD):  Conforms to ASTM B633, Type II SC1 or SC3
    • Plain (PL):  No finish 

    Materials & Finishes - Special Metals:

    • Stainless Steel, Type 304 (SS):  Conforms to ASTM A240 or A276, Type 304 *
    • Stainless Steel, Type 316 (ST):  Conforms to ASTM A240 or A276, Type 316 *
    • Aluminum (AL):  Conforms to ASTM B209, Type 1100F or 5052-H32 *

    * These materials have different physical properties and performance characteristics. Please contact us for design support.